The drive Samsung SSD 850 EVO 500GB has logged 2,163,416 CRC error(s) on its SATA interface, a high count that points to a connection problem. This is NOT a drive failure; the drive itself is likely healthy, but the cable, port, or backplane carrying its data was unreliable when the errors occurred. The counter is cumulative over the drive's whole lifetime, so these errors may be years old and come from an issue that has long been resolved.
If the count is still increasing, reseat or replace the SATA data cable, try a different SATA port, and check for issues with the drive sled or backplane in this chassis. If multiple drives in the same system show CRC errors, the chassis wiring is the likely culprit.
The drive SAMSUNG MZVLW1T0HMLH-000L7 has spent 54 minute(s) operating above its warning temperature threshold (typically 70°C). The drive is still functional but is running hotter than its manufacturer recommends for sustained operation, which gradually shortens its lifespan.
Check airflow and cooling around the drive. Adding a heatsink or improving case ventilation usually resolves this.
The drive SAMSUNG MZVLW1T0HMLH-000L7 has reported 4 media error(s).
Media errors indicate that the drive was unable to read from or write to the NAND media successfully. A small number of media errors may be recoverable, but any increase can indicate failing flash cells, controller issues, or progressive drive degradation.
Back up any important data on this drive immediately, monitor the error count for further increases, and consider replacing the drive if the count continues to rise or reaches a critical level.
The drive WDC WD1002FBYS-02A6B0 has accumulated 79,297 hours of powered-on time, about 9.1 years, far beyond the 5-year design service life typical for hard drives.
Field data shows hard drive failure rates climbing steeply once a drive is several years past its rated service life. At this age, a mechanical or electronic failure can occur with little or no SMART warning.
Back up any important data on this drive now and plan its replacement. A drive this old should no longer be trusted as the only copy of anything valuable.
We detected 1 storage device(s) that are not partitioned or formatted. The affected device(s) are: TOSHIBA MD04ACA400. Windows cannot use these drives until they are initialized and set up.
Open the Disk Management tool to initialize the device(s), create a partition, and format the drive so it becomes usable.
The drive TOSHIBA MD04ACA400 has reported 81912 media error(s).
Media errors indicate that the drive was unable to read from or write to the NAND media successfully. A small number of media errors may be recoverable, but any increase can indicate failing flash cells, controller issues, or progressive drive degradation.
Back up any important data on this drive immediately, monitor the error count for further increases, and consider replacing the drive if the count continues to rise or reaches a critical level.
Scan this QR code
To open this page on your phone
Previous validations from this PC
Unexpected crashes (BSOD)
No unexpected crashes (BSOD) recorded on this PC.
Boot Time details
Hardware errors (WHEA)
No hardware errors recorded in the Windows event log.
Driver problems
No driver problems detected.
Flagged processes
29 running processes, none flagged.
Inform a support service
If a partner support service is helping you with this PC, enter the service code they gave you to send them this validation. A valid service code is required.